Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Repair in Houston, TX
Gate access control in Houston means keeping an automated gate working through clay soil movement, tropical downpours, and humidity that corrodes boards faster than almost anywhere in Texas. Most Houston homes with driveway gates were built after 1970, and their original operators and keypads are now reaching the end of their service life. Call (346) 488-1637 when a keypad stops responding, an intercom goes silent, or a gate won’t open from the street.
Why Houston Homes Are Different
Houston’s Beaumont clay soil expands when wet and shrinks during dry spells. Gate posts shift out of plumb, swing arms bind, and slide gates drag on their rails. This happens seasonally, even to gates installed correctly ten years ago. River Oaks and Memorial have ornate iron estate gates with custom hinges and operator mounts that were fabricated to fit a specific post spacing; when the post moves even a quarter inch, the whole assembly fights itself. In neighborhoods near Brays Bayou, Buffalo Bayou, and the Addicks and Barker watersheds, floodwater has submerged operators and control boards. A gate that worked fine for months after Harvey may develop intermittent faults a year later because a circuit board was quietly corroding the whole time. That pattern, a flood-damaged board failing long after the storm, is one of the most common calls we see across Houston. Humidity over 90 percent in summer means unsealed operator housings and bare steel welds rust through within a few years unless they are coated and sealed correctly.
Our Main Houston Services
Most Houston homeowners reach us through one of three doors: the gate won’t move, the gate needs to be replaced, or the motor that drives the gate has failed. Here is what each service looks like in Houston.
Gate Repair in Houston
A leaning post in Katy or a drag mark on a slide gate in Sugar Land usually points to clay soil movement rather than a bad motor. Houston repair work is diagnostic: find what moved, measure how far, and correct it. Flood-damaged boards in bayou-adjacent subdivisions need replacement, not a reset. Our Gate Repair in Houston work always includes a written price before we touch the gate, and a photo record of every adjustment before we leave.
Gate Installation in Houston
New gates in Houston need deeper post settings than in drier Texas cities because clay expands and contracts through every wet and dry cycle. A post set too shallow will walk out of plumb within two seasons. For Gate Installation in Houston, we set posts below the active soil line, seal welds against humidity, and use operator housings rated for flood-prone yards where the elevation calls for it. Every installation gets a written scope and price first.
Gate Motor & Opener in Houston
The original operator on a 1990s Cinco Ranch or Kingwood gate is at end of life. Motors run hot in Houston summers, and boards in unsealed housings fail from condensation even without flooding. When we replace or service a motor, we photograph the limit-switch positions and wiring before and after so the next technician works from record, not guesswork. See Gate Motor & Opener in Houston for details.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
BeforeAfterGate Access Control in Houston
Houston’s post-1970s suburban expansion produced thousands of automated residential and community entrance gates. The original keypads, intercoms, and card readers installed with those gates in the 1990s and early 2000s are now failing from age, humidity, and occasional flood exposure. Our Gate Access Control work covers every part of the system that lets someone in or keeps someone out.
Keypad Entry
Signs you need it
The keypad backlight is on but gate won’t open, or some codes work and others don’t.
What it costs in Houston
A keypad replacement in Houston typically runs $150-$400 installed, depending on the brand and whether the wiring is intact.
How we do it
We test voltage at the keypad, replace the unit, reprogram codes, and photograph the finished wiring.
Video Intercom
Signs you need it
Callers at the street hear nothing, or video works but the gate release button doesn’t.
What it costs in Houston
A video intercom replacement in Houston typically runs $400-$1,200 depending on panel brand and cabling condition.
How we do it
We check the power supply and cable continuity, swap the failed component, and test the call and release functions.
What Gate Access Control Costs in Houston
| Item | Typical range in Houston |
|---|---|
| Keypad replacement | $150-$400 |
| Card reader replacement | $180-$450 |
| Video intercom replacement | $400-$1,200 |
Can you fix a Houston keypad the same day?
Yes, in most cases. Keypad replacements are stock items on our trucks, and we can typically complete the job in one visit. Call (346) 488-1637 to schedule.
Does a Houston video intercom need special weather protection?
It should have a sealed housing and gasketed faceplate. Houston’s humidity and storms ruin unprotected units quickly. We install weather-rated panels and seal all exterior penetrations.
Gate Parts & Welding in Houston
Houston’s gate hardware corrodes faster than in any other major Texas city. Annual rainfall over 50 inches, summer humidity near 100 percent, and tropical storm surges mean bare steel hinges, welds, and roller assemblies rust through within a few years unless sealed. Gate Parts & Welding covers the structural and mechanical components that keep a gate standing and moving straight.
Hinge Replacement
Signs you need it
The gate sags, scrapes the ground at the latch side, or the hinge pin is visibly rusted through.
What it costs in Houston
Hinge replacement in Houston typically runs $180-$450 depending on gate weight and the condition of the post.
How we do it
We unload the gate, cut off the failed hinge, weld a new one, and re-hang the leaf level.
Post Replacement
Signs you need it
The gate post leans, the latch no longer aligns, or the base shows fresh cracks from soil movement.
What it costs in Houston
Post replacement in Houston typically runs $400-$900 including concrete and setting through the active clay zone.
How we do it
We saw out the old post, dig below the shrink-swell zone, set the new post in concrete, and rehang the gate square.
What Gate Parts & Welding Costs in Houston
| Item | Typical range in Houston |
|---|---|
| Hinge replacement | $180-$450 |
| Post replacement | $400-$900 |
| Custom welding repair | $150-$600 |
Can you weld a broken iron gate in Houston without replacing it?
In most cases yes. We grind out the crack, weld the joint, and coat the repair against Houston humidity. The written quote covers the full repair before work starts.
How long do Houston gate hinges last?
Unsealed steel hinges in Houston can rust through in three to five years. Coated, greased, and maintained hinges last significantly longer. We photograph hinge condition on every visit.
Brands We Service in Houston
We service LiftMaster, FAAC, Elite, and Mighty Mule operators, plus six other major automation brands. Boards and common parts are stocked locally for most models. See our brands for the full list. Turnaround on same-brand replacements is usually one visit.
Pricing for Gate Repair in Houston, TX
| Service | Typical range in Houston |
|---|---|
| Keypad replacement | $150-$400 |
| Card reader replacement | $180-$450 |
| Video intercom replacement | $400-$1,200 |
| Hinge replacement | $180-$450 |
| Post replacement | $400-$900 |
| Custom welding repair | $150-$600 |
Prices in Houston run higher when a gate has been flooded and the board, wiring, and operator all need replacement at once, or when custom iron estate gates require fabricated parts matched to an existing design. We hand you a written price before any work begins, and the price we quote is the price you pay.
Neighborhoods We Serve in Houston
Our Houston crews work across the metro daily. Typical response time for a repair call is same day or next morning, and our dispatch is coordinated from the Houston office. We regularly work in:
- Katy
- Cinco Ranch
- Kingwood
- Sugar Land
- River Oaks
Service Area - Cities Near Houston
We also serve homeowners in nearby communities including Galena Park, TX, Channelview, TX, Bellaire, TX, and Humble, TX. Scheduling for those areas runs through the same Houston office.
Serving Houston, TX - Our Local Coverage Area
We’re based in the Houston area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Repair in Houston
In most cases yes for an active repair. A live person answers (346) 488-1637 around the clock, and we dispatch Houston crews daily. Same-day service depends on your location and the work required, but we will tell you honestly before you commit.
In many Houston master-planned communities, yes. HOAs in Katy, Kingwood, and Sugar Land often require approval for gate replacement or post work. We provide a written scope you can submit, and we install to the specs your HOA sets.
That is a common pattern in Houston after storms like Harvey. Water enters the operator housing, corrodes the board, and it fails intermittently before dying. We check for flood exposure first when diagnosing an electrical fault on any Houston gate. Call (346) 488-1637 for a free estimate. We hand you the written price before any work starts.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Houston Customers Say
"They installed the opener and left me a diagram of the wiring and the limit settings. When I needed a second remote programmed I could do it myself."
- Nadine C."The safety loop had never been installed correctly by the previous company. They showed me the reading, fixed it, and did not charge me for the diagnosis."
- Patrick H."Quoted in writing, installed on the day promised, and the price did not move. The crew was licensed and the number was on the paperwork."
- Wes A.